Guider II

280 x 250 x 300mm  21 Litres

The large build volume makes the Guider II not only enables you to produce impressive size prototypes up to 21 litres in volume, it also gives you the flexibility to print multiple models in the one build cycle.

The print surface of the Guider II is constructed of Tempered Glass and covered with an ultra adhesive polymer and can heat up to 120°C. Radiant heat from the large print bed effectively heats the enclosure of the Guider II. This significantly reduces warping of large models in engineering materials.

The Guider II is a tough machine, built around a rigid aluminum chassis, this ensures superiour print quality an high print speeds.

Constructed with oversized linear shaft rods and bearings as well die cast aluminum gantry brackets and injection moulded fittings. No 3d printed parts in sight.

Filament Run Out Detection

The Guider II will detect when filament is running low. It will automatically pause, allowing you to replace the filament spool and continue the build.

Resume On Power Outage

In the event of a power failure during the print process, an internal energy storage will move the print head to the side to protect it from damage. Once power is resumed the printer shall prompt you to resume where it left off.

A retractable bed leveling sensor is used to measure the print surface ensuring a perfect leveled bed every time.

This optional upgrade all metal hot end assembly (sold separately) will enable the Guider II to print at higher temperatures - up to 300°C.
This will enable you to print engineering grade materials such as ABS+, Nylon and Polycarbonate.

Check the status, slice send and share files, create print queues for multiple machines from the one interface.